Enter Grain Refining Data:       Enter percent Ti of grain refiner used: Enter Desired Ti content (%) OR FEED ROD AT (ipm) Enter Desired B or C content (ppm) Enter B or C content of grain refiner used Enter the metal FLOW RATE if known: (lbs./min.)       If FLOW RATE not known, enter the following data: RECTANGULAR INGOT Width (inches) Length (inches) Number of pieces cast FEED ROD AT (ipm) Enter casting speed (ipm) Your Flow Rate is       ROUND INGOT Diameter Number of pieces cast FEED ROD AT (ipm) Casting speed (ipm) Your Flow Rate is